三轴气缸/TCL、TCM系列三轴气缸/亚德客三轴气缸

Matters needing attention：
When the load changes in the work, should choose the output force of the cylinder;

Under high temperature or corrosive conditions, the corresponding high temperature or corrosion resistant cylinder should be selected;

In the case of high humidity, dust, or water droplets, oil pressure, welding slag, the cylinder should take appropriate protective measures;

Before entering the pipe, it is necessary to know the dirt inside the pipe to prevent debris from entering the cylinder;

The use of the cylinder should be more than 40 m filter filter before use;

The lateral load of the cylinder should not exceed the allowable value in order to maintain the normal operation and service life of the cylinder;

In low temperature environment, measures should be taken to prevent freezing of water in the system;

Cylinder removed for a long time not to use, should pay attention to the surface rust, gas inlet and outlet should be added to protect the blockage cap, due to the high accuracy of product production and guidance, do not disassemble the cylinder block or cylinder head.

工作中负载有变化时，应选用输出力充裕的气缸；

在高温或者腐蚀性条件下，应选用相应的耐高温或耐腐蚀性气缸；

在湿度大，粉尘多，或者有水滴、油压、焊渣的场合，气缸应采取相应的防护措施；

气缸接入管道前，必须清楚管道内脏物，防止杂物进入气缸内；

气缸使用介质应经过40μm以上滤芯过滤后方可使用；

气缸在工作过程中所受侧向载荷不应超过允许值，以维持气缸的正常工作和使用寿命；

在低温环境下，应采取抗冻措施，防止系统中的水分冻结；

气缸拆下长时间不使用，要注意表面防锈，进排气口应加防护堵塞帽，由于产品制作与导向精度高，请不要自行拆卸气缸固定块或气缸盖。